Traffic Control

The following scenario shows how to configure a basic traffic control discipline, which can be used for traffic shaping and scheduling purposes on OSDx. The monitor test performance operational command can be used to calculate the throughput.

../../../_images/topology3.svg

Test Traffic Control

Description

In this scenario, a fair queuing controlled delay qdisc (fq-codel) is configured in DUT0.

Scenario

Step 1: Set the following configuration in DUT0:

set interfaces ethernet eth0 address 10.0.0.2/24
set interfaces ethernet eth0 traffic control out QDISC
set traffic control QDISC type fq-codel

Step 2: Set the following configuration in DUT1:

set interfaces ethernet eth0 address 10.0.0.1/24

Step 3: Ping IP address 10.0.0.1 from DUT0:

admin@DUT0$ ping 10.0.0.1 count 1 size 56 timeout 1
Show output
PING 10.0.0.1 (10.0.0.1) 56(84) bytes of data.
64 bytes from 10.0.0.1: icmp_seq=1 ttl=64 time=0.488 ms

--- 10.0.0.1 ping statistics ---
1 packets transmitted, 1 received, 0% packet loss, time 0ms
rtt min/avg/max/mdev = 0.488/0.488/0.488/0.000 ms

Step 4: Initiate a bandwidth test from DUT0 to DUT1

admin@DUT1$ monitor test performance server port 8080
admin@DUT0$ monitor test performance client 10.0.0.1 duration 5 port 8080
Expect this output in DUT0:
Connecting to host 10.0.0.1, port 8080
[  5] local 10.0.0.2 port 57126 connected to 10.0.0.1 port 8080
[ ID] Interval           Transfer     Bitrate         Retr  Cwnd
[  5]   0.00-1.00   sec   235 MBytes  1.97 Gbits/sec    0   1.22 MBytes
[  5]   1.00-2.01   sec   231 MBytes  1.93 Gbits/sec  470   1.64 MBytes
[  5]   2.01-3.00   sec   231 MBytes  1.95 Gbits/sec   10   1.25 MBytes
[  5]   3.00-4.00   sec   246 MBytes  2.06 Gbits/sec    0   1.30 MBytes
[  5]   4.00-5.00   sec   229 MBytes  1.92 Gbits/sec    0   1.38 MBytes
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval           Transfer     Bitrate         Retr
[  5]   0.00-5.00   sec  1.14 GBytes  1.97 Gbits/sec  480             sender
[  5]   0.00-5.00   sec  1.14 GBytes  1.97 Gbits/sec                  receiver

iperf Done.

Step 5: Run command traffic control show at DUT0 and check if output contains the following tokens:

fq_codel
Show output
Traffic control for interface 'eth0' - 'egress' mode

---------------------------------------------------------------------------
ID   traffic control    type    parent  bytes sent  pkts sent  pkts dropped
---------------------------------------------------------------------------
1:0  QDISC            fq_codel  root    1286332007     852994             0