Check Connection

This scenario shows how to create a bridge interface using an Ethernet interface.

Test ICMP Connectivity

Description

A bridge interface is created in DUT0 by using a single Ethernet interface. Once it’s configured, the ‘Ping’ command is used to check if there’s connectivity between both nodes.

Scenario

Step 1: Set the following configuration in DUT0:

set interfaces bridge br0 address 192.168.100.10/24
set interfaces ethernet eth0 bridge-group bridge br0

Step 2: Set the following configuration in DUT1:

set interfaces ethernet eth0 address 192.168.100.20/24

Step 3: Ping IP address 192.168.100.20 from DUT0:

admin@DUT0$ ping 192.168.100.20 count 1 size 56 timeout 1

Show output

PING 192.168.100.20 (192.168.100.20) 56(84) bytes of data.
64 bytes from 192.168.100.20: icmp_seq=1 ttl=64 time=0.458 ms

--- 192.168.100.20 ping statistics ---
1 packets transmitted, 1 received, 0% packet loss, time 0ms
rtt min/avg/max/mdev = 0.458/0.458/0.458/0.000 ms

---